|
#1
12-14-2009, 09:07 PM
|
||||
|
||||
Has this ever happened to your Secondary?
Started to get a pretty bad vibration about half way through our ride today, took it slow, thought it was the track, tightened suspension bolts and aligned the rear skid, no problems, still vibrating. Thought I might have a chunk taken out of the belt, and this wasnt it either. Going back to the truck it got progressivly worse, I stopped and then started again and heard the sqeuel of the belt, only to find that my torsional set up was cracked, how the hell did this happen, has it happened to you?
|
|
#4
12-14-2009, 10:30 PM
|
||||
|
||||
|
Quote:
|
|
#5
12-14-2009, 10:39 PM
|
||||
|
||||
|
Honestly I would never have thought that could happen. Is that helix cut from billet aluminum?
Maybe some type of material quality inconsistency or defect? On a side note what kind of rollers are those? To hold up to that kind of abuse without crumbling to pieces is impressive.
|
|
#6
12-14-2009, 10:49 PM
|
||||
|
||||
|
yep...seems to be unforseen contaminants in the alloy...nobodys fault that it would not get noticed...i bet if you broke it all the way you would see the impurities
__________________
07/m8 Terraalps 900 bigbore kit, bmp ypipe and exhaust,jaws silencer,stm valves,bdx oil elimination and bumper kit,fastlane no snows,bdx fuel pressure regulator,dayton adj weights,shift assist,timbersled intake,timbersled mtn tamer rear skid,timbersled barkbuster frt end with fox evols diamond s hood,pure logic box,boss shorty seat,rox risers,koso dual egts koso a/r guage koso water temp guage,bdx steering post solidifier,fastlane 9 inch two wheel kit,rock rollers,Mod ski's
|
|
#7
12-14-2009, 10:52 PM
|
||||
|
||||
|
Quote:
|
 |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
