09 Summit Everest windshield question

[Pell]

I have an 09 Summit Everest. I replaced the big original windshield with a low Summit X windshield. Does anyone know if Ski-doo makes any type of plug to fill the 4 holes that were used for the sides of the original windshield? I can probably find something that will work at the hardware store but figured I'd check here.

[powderblind]

As far as I know I have not seen anything while browsing through the accessories catalog. I really wouldn't worry about plugging them if anything they will just help let out hot air.

[snowfreakmn]

I went to the hardware store and got snap in plastic plugs for the hood and where the sway bar use to be.

[REV4ARUSH]

If you take the rubber grommets out, I think they look good with the holes there. Poor mans vent kit

[Xrider]

Yes, your dealer should have the plugs....mine did.

[Pell]

Part numbers? Thanks.

[Wapow]

You can get cheap plastic plugs that fit well and look good at any auto parts store. Think they're called panel fasteners. My dealer didn't have anything, but that's no surprise.

[Wade]

Save that tall windshield.

Just take it over to the table saw and cut it down to the size you want, then glue the trim back on.