Go Back   Back Country Rebels - Forums > CLASSIFIEDS > Parts and Accessories > Snowmobile

Reply
 
Thread Tools Display Modes
  #1  
Old 06-15-2012, 08:01 PM
SummitX1000's Avatar
SummitX1000 SummitX1000 is offline
REBEL
 
Join Date: Nov 2009
Location: Sandy, UT
Posts: 5,515
SummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLP
SummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLP
Default Mostly RT Parts, with a few misc. Rev and S-Chassis Parts

Time to clean up the garage!!!

A few years back I broke a connecting rod in my RT and caused quite a bit of carnage. The damage was not repairable so I ended up getting another engine. Since that time the old engine has sat on the workbench taking up space, and it's time for it to go!! It will be easiest to list what isn't good, everything else is up for grabs. I am just starting the cleanup process so please bear with me until I can get pictures and prices up. In the mean time I'm willing to accept reasonable offers on parts and can get pictures posted of those parts as needed. Also I will try to respond as quickly as possible to your posts and PM's, but life is busy right now, so don't get discouraged if it takes a day or 2 for me to get back to you. I want this stuff gone, so I will respond, it just may or may not be right away. Engine had about 1600 miles on it.

Ok, so the parts of the engine that are not good are:

Top half of the crank case
Cylinders
Half of one reed valve
Pistons
One Connecting Rod

Parts that have been SOLD:

Bottom half of the crank case
Water Pump and Housing
Oil Pump
Water/Oil Pump Shaft
Rave Valve Assembly
Fuel Rail and Injectors
Balance Gears
Piston Pins
Throttle Cable

Those are the parts I know for sure are not usable. The crank looks to be in good condition from what I can tell. There are a couple of marks/nicks on it from flying debris when the connecting rod broke, but other than that all the bearings move freely and everything else seems to be fine. Obviously you would want to have it checked out before using it, but I just want to put out the information I know. As I disassembled the engine I just threw most of the bolts into a bucket, so if you need any of those I would rather just get rid of those as 1 lot. I won't know what bolt goes to what at this point.

That pretty much covers the engine. I do have a few misc. oil lines, coolant hoses, coolant reservoir and the engine mounts as well.

Other RT parts:

Blue Trunk assembly - $50 + Shipping
Blue (clutch) Side panel - $50 + Shipping
Yellow Knee Deflectors - $15 + Shipping
Yellow Snow Flap - SOLD
Sway Bar - $20 + Shipping
Ceramic Coated "The Thing" Can - $65 + Shipping

Rev parts:

Yellow Trunk assembly - $50 + Shipping
Running Board Reinforcement Kit - 861804300 (Never used, In open package) - $50 + Shipping

Parts that may fit Rev OR RT (Buyer is responsible for fit verification):

515175943 - Tachometer - $50 + Shipping
515176478 - Tachometer - $50 + Shipping
515176477 - Speedometer - $100 + Shipping
861509300 - Lens and Reflector Kit (This is a clear lens with a red inner lens) The lens is used but the reflector was never used. - $20 + Shipping

S-Chassis Parts: (all came from a 1996 MXZ 670)

Engine Torque arm (Minus the rubber bumper pad) - $10 + Shipping
White Face Tachometer - $25 + Shipping
Black Face Speedometer (Odometer works, but Speedometer Needle does not) - $FREE + Shipping
Black Face Tachometer - $15 + Shipping
Pull Start Trim Panel - $5 + Shipping
Brand New (take off) Driveshaft assembly with drivers - $100 + Shipping
Heat exchangers (pair) - $100 + Shipping
Cover for a 2-up S-Chassis Sled. Used for about 2 years. A bit faded, but otherwise in good shape. - $50 + Shipping

That's about all I can think of for now. I will add more if I come across it. Pictures are posted below, and I will also add more pictures as time allows.























Running Board Reinforcement Kit - 861804300

Yellow REV Trunk



Blue RT Trunk



CKX Helmet w/ Heated shield - $100 Shipped


S-Chassis White Face Tachometer

S-Chassis Black Face Speedometer (Odometer works, but Speedometer Needle does not)

S-Chassis Black Face Tachometer

515176478 - Tachometer


515175943 - Tachometer


515176477 - Speedometer


S-Chassis Pull Start Rope/Handle Panel

S-Chassis Drive Axle Assembly (9-Tooth Drivers)


__________________
We've been knocked down, we'll get up.
From the ashes we rise!
We've been kicked around, sure enough.
We will survive!

Marty
Rebel #87

Utah Avalanche Center.

I finally found the pot under the rainbow & wouldn't you know it...some asshole has already smoked it!

Last edited by SummitX1000; 12-20-2014 at 11:31 PM. Reason: Added prices for parts. Added more pictures.
Reply With Quote
  #2  
Old 07-07-2012, 03:50 PM
SummitX1000's Avatar
SummitX1000 SummitX1000 is offline
REBEL
 
Join Date: Nov 2009
Location: Sandy, UT
Posts: 5,515
SummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLP
SummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLP
Default

Added more pictures to the first post and Prices for parts.
__________________
We've been knocked down, we'll get up.
From the ashes we rise!
We've been kicked around, sure enough.
We will survive!

Marty
Rebel #87

Utah Avalanche Center.

I finally found the pot under the rainbow & wouldn't you know it...some asshole has already smoked it!
Reply With Quote
  #3  
Old 01-18-2013, 09:40 PM
SummitX1000's Avatar
SummitX1000 SummitX1000 is offline
REBEL
 
Join Date: Nov 2009
Location: Sandy, UT
Posts: 5,515
SummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLP
SummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLPSummitX1000 Offical PLP
Default

BUMP
__________________
We've been knocked down, we'll get up.
From the ashes we rise!
We've been kicked around, sure enough.
We will survive!

Marty
Rebel #87

Utah Avalanche Center.

I finally found the pot under the rainbow & wouldn't you know it...some asshole has already smoked it!
Reply With Quote
  #4  
Old 01-21-2013, 02:45 AM
broncoformudv's Avatar
broncoformudv broncoformudv is offline
Prospect
 
Join Date: May 2011
Location: Fort Richardson, Alaska
Posts: 497
broncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from AR
broncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from ARbroncoformudv Has earned a rub and tug from AR
Default

Do you have a pic of the cover?
Reply With Quote
Reply
Back Country Rebels - Forums > CLASSIFIEDS > Parts and Accessories > Snowmobile

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 04:30 PM.

 

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Managed by wDa @ WD ™

Designed by Military Ltd